Paxton Superchargers Mustang Cobra, NOVI 1000 System User Manual
Page 16
P/N: 4809640
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
03APR06 v1.0 01Cobra(4809640v1.0)
2
Fig. 3-e
Fig. 3-f
Fig. 3-g
Fig. 3-h
D.
Remove bolt from factory idler pulley and
discard . (See Fig. 3-e.)
E.
Mount the supplied idler pulley, snap-ring
side facing out, on the idler support bracket
using the supplied hardware . Trial fit the idler
pulley first; if it does not fit, one of the ribs
on the alternator must be ground off . (See
Fig. 3-f.)
When the pulley clears the alternator it can be
bolted into place . Install the stock idler pulley
in its original location, followed by the water
pump pulley using the factory hardware . (See
Fig. 3-g.)
F.
Install the supplied accessory/supercharger
drive belt and route as stock, but do not install
on alternator pulley until after the supercharg-
er is installed . Instead, leave a loop in the belt .
(See Fig. 3-h.)
G.
Install the rear S/C mounting bracket as
shown . (See Fig. 3-h.) Be sure to install the
idler pulley spacer, wiring loom tab, and spac-
er . (Refer to Appendix ‘C’ for more detail)