Paxton Superchargers Mustang Cobra, NOVI 1000 System - Manual (Page 23)

P/N: 4809640
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
03APR06 v1.0 01Cobra(4809640v1.0)
1
Fig. 6-a
Fig. 6-b
Fig. 6-c
Fig. 6-d
These steps illustrate how to install the new intake sys-
tem .
A. Disassemble to supplied air intake as shown,
leaving the hose clamp indicated loose so the
elbow can be rotated once the assembly is
mounted in the car . (See Fig. 6-a .)
lEAVE lOOSE
B. Remove the two nuts located in the passenger
side inner fender wall . Push the mass air
meter/air filter assembly and inlet tube up into
the passenger side fender, and attach to the
existing studs in the inner fender panel using
the two factory nuts . (See Fig. 6-b .)
D. Assemble the inlet tract as shown, with the
rubber elbow clamped to the plastic inlet tube
and the bypass valve assembly in place .
Route the long PCV tube from the underside
of the plastic inlet tube to the PCV fitting on
the passenger side valve cover . Tuck the free
end of the bypass valve assembly underneath
the cast aluminum discharge tube . Insert the
plastic intake tube into the flex hose, and the
rubber elbow onto the supercharger inlet . (See
Fig. 6-d .)
C. Attach the length of flex hose to the plastic
elbow on the MAF/air filter assembly inside
the fender (See Fig. 6-c .) Install the cast-alu-
minum discharge tube using the supplied rub-
ber joints and stainless steel clamps .
E. Once you have determined that the inlet tube
assembly is positioned properly, tighten all
clamps .
Section 6
AIR INTAKE SYSTEM MODIFICATIONS
6. AIR INTAKE SYSTEM
MODIFICATIONS