Paxton Superchargers Mustang Cobra, NOVI 1000 System User Manual
Page 8
P/N: 4809640
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
03APR06 v1.0 01Cobra(4809640v1.0)
2
D.
Unplug the EGR sensor, located at the rear
most portion of the upper plenum . (See
Fig. 1-e.)
G.
Lift the upper plenum up, and disconnect the
two small vacuum hoses located at the rear of
the plenum . Lay the plenum onto the driver’s
side of the engine compartment . (See
Fig. 1-h .)
H.
Relieve the pressure in the fuel rail by
depressing the small Schraeder Valve with a
phillips head screwdriver . A small amount of
fuel will come out of the valve, so have a
clean rag ready . Remove the 10mm bolts (2
per side) that secure the fuel rails to the intake
manifold . (See Fig. 1-i .)
E.
Using a 1-1/16" open end wrench, loosen the
EGR tube, located at the rear of the EGR
valve . (See Fig. 1-f .)
Fig. 1-e
Fig. 1-h
Fig. 1-i
Fig. 1-f
Fig. 1-g
F.
Remove the eight 8mm upper plenum bolts .
(See Fig. 1-g .)
I.
Lift the rails up and remove the stock injectors
from the intake manifold . The injectors are
sealed with O-rings and may be difficult to
remove, but they will come out . Replace them
with the supplied High Performance Injectors .
(See Fig. 1-j.)