Paxton Superchargers Ford V-10 Super Duty Truck User Manual
Page 12
1-4
P/N: 4809606
©2005 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
06SEP05 v4.0 FordV10(4809606v4.0)
F.
Reclip the two large connectors back onto the
modified stock bracket (from Step E). Attach
the bracket and connectors with the two sup-
plied wire ties to the heavy-duty plastic wire
loom as shown. (See Fig. 1.4-e.)
Fig. 1.4-e
G.
Located on the driver’s side, in front of the
cylinder head is the cam sensor. Extend the two
wires coming from the cam sensor along with
the shielded white wire that runs parallel with
the cam sensor wires, using the supplied three
wires and six Butt connectors. (See Fig. 1.4-f.)
H.
Then cover the wires with the supplied split-
loom. Route the extended wires under the upper
most stud sticking out of the front of the engine
then back over toward the harness.
Fig. 1.4-f