Paxton Superchargers Ford V-10 Super Duty Truck - Manual (Page 11)

1-3
P/N: 4809606
©2005 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
06SEP05 v4.0 FordV10(4809606v4.0)
A. On the front of the engine, (driver’s side), you
will find two large black electrical connectors
attached to a bracket. (See Fig. 1.4-a.)
B. Remove plugs from the bracket (see Fig. 1.4-b)
and disconnect both plugs; one requires a
10mm socket wrench.
C. Next, unbolt the bracket that held the two elec-
trical connectors and modify the bracket as in
(See Fig. 1.4-c.)
D. Discard the part with the two holes in it and
retain the section that the electrical connectors
clip to. The two connectors and wiring harness,
will now be routed directly in front of the two
steel brake lines.
E. Lift the wiring harness in the plastic sheath off
the studs on the driver’s side valve cover. Push
it down into the area between the valve cover
and the intake manifold. Now take the large
wiring harness and two connectors that runs
along the top of the motor and fold the wiring
harness back onto itself as shown. (See Fig.
1.4-d.)
Fig. 1.4-b
Fig. 1.4-c
Fig. 1.4-a
CUT HERE
1.4 WIRE ROUTING AND MODIFICA-
TIONS
Fig. 1.4-d
DISCARD
THIS SECTION