Paxton Superchargers Ford V-10 Super Duty Truck - Manual (Page 9)

1-1
P/N: 4809606
©2005 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
06SEP05 v4.0 FordV10(4809606v4.0)
A. Using a screwdriver, remove the black rubber
tube between the throttle body and the air
cleaner by loosening the two hose clamps.
Disconnect the two rubber hoses attached to the
side of the tube. (See Fig. 1.1-a.)
B. Carefully pull the air inlet temperature sensor
out of the black rubber hose attached to the side
of the plastic inlet tube. (See Fig. 1.1-b.)
tion between the throttle body and front air fil-
ter enclosure. You will need to unplug the Mass
Airflow Sensor connector on the inner fender-
well. Using a 10mm socket and ratchet, remove
the three bolts securing the air filter bracket and
remove it from the vehicle. (See Fig. 1.1-c.)
D. Gently pry the air flow meter cover plate from
the air filter housing using a screwdriver. Next,
push the large rubber grommet (surrounding the
4 Mass Airflow Meter wires) into the housing
and finish removing the Mass Airflow Meter.
(See Fig. 1.1-d.)
*** NOTE ***
Model Year 2000 will NOT have this sensor.
Section 1
INITIAL PREPARATION AND DISASSEMBLY
1.1 AIR INTAKE DISASSEMBLY
C. Un-snap the large clamp which holds the air
cleaner housing together and remove the sec-
Fig. 1.1-a
Fig. 1.1-b
Fig. 1.1-c
Fig. 1.1-d
IAT SENSOR