Dell 3 - Manual (Page 104)

102 PERC 3/SC Hardware Installation
w
w
w
.d
e
ll
.co
m
|
s
u
p
p
o
rt
.d
e
ll.c
o
m
Requirements
This chapter describes the installation procedures for the PERC 3/SC
board. You must have the following:
• A PERC 3/SC controller
• A host computer with an available 5 V, 32- or 64-bit PCI expansion slot
• The PERC 3 installation diskettes
• The necessary SCSI cables (This depends on the number and type of
SCSI devices to be attached.)
• Fast, Ultra, Ultra II, and 160M SCSI hard drives
Dell™ strongly recommends that you have an uninterruptible power supply
(UPS) for the entire system.
Optional Equipment
You may also want to install SCSI cables that connect the PERC 3/SC to
external SCSI devices.