Step 1—unpack, Step 2—power down – Dell 3 User Manual
Page 106
104
PERC 3/SC Hardware Installation
w
w
w
.d
e
ll
.co
m
|
s
u
p
p
o
rt
.d
e
ll.c
o
m
6
Connect the SCSI cables to SCSI devices.
Make sure all cables are properly attached, and that the PERC 3/SC
card is properly installed.
7
Set the target IDs for the SCSI devices.
8
Replace the computer cover and turn the power on.
Be sure the SCSI devices are powered up before or at the same time as
the host computer.
9
Run the PERC 3 BIOS Configuration Utility or WebBIOS
Configuration Utility to configure arrays and logical drives.
10
Install software drivers for the desired operating systems.
Step 1—Unpack
Unpack and install the hardware in a static-free environment. The PERC 3
is packed inside an anti-static bag between two sponge sheets. Remove the
controller card and inspect it for damage. If the card appears damaged, or if
any item listed below is missing, contact your Dell support representative.
The PERC 3 controller also comes with:
• The PERC 3 User’s Guide
• A license agreement
• The PERC 3 configuration utilities diskette
Step 2—Power Down
Turn off the computer and remove the cover. Make sure the computer is
disconnected from any networks before you install the controller card.