Connecting the power cord, Once connections are completed, External controller – Denon AV SURROUND RECEIVER AVR-5308CI User Manual

Page 27: Turning the power on

Advertising
background image



Get
ting Star

ted

Set
up

Pla
ybac

k
Remot

e Contr

ol

Multi-Zone

Inf
or

mation

Tr

oubleshooting

NOTE

• Insert the AC plugs securely. Incomplete connections could cause noise.
• Only use the AC outlets to plug in audio devices. Do not use them as power supplies for hairdryers or

anything other than audio equipment.

Wait until all connections have been completed before connecting the power cord.

To household

power outlet

(AC 120 V, 60 Hz)

Power cord

(included)

Connection to the AC outlets

• These outlets supply power to external audio

devices.

• The power supplied from these outlets turns on and

off together with the set’s power switch.

• Audio equipment with a total power consumption

of 120 W (1 A) can be connected.

Connecting the Power Cord

Trigger output jacks

The power of an external device equipped with
a trigger input jack can be turned on and off in
association with operations on the AVR-5308CI.
For details, see GUI menu “Manual Setup” –
“Option Setup” – “Trigger Out 1”, “Trigger Out 2”,
“Trigger Out 3” or “Trigger Out 4” (vpage 41).
• Output level: 250 mA/12 V

Check the trigger input conditions of the
connected device.

External Controller

• When using in combination with an RF Remote Controller (RC-7000CI, sold separately) and RF Remote

Receiver (RC-7001RCI, sold separately) two-way communication with an RF Remote Controller is possible.

The AVR-5308CI’s status information as well as iPod and Internet audio music files can be browsed

watching the RF Remote Controller’s display. For details, refer to the operating instructions of the

respective devices.

• When used in combination with an RF Remote Controller and RF Remote Receiver, make the settings at

GUI menu “Manual Setup” – “Option Setup” – “2Way Remote” – “Used” (vpage 41).

• When using the 2-way remote control unit, connect to the Port 1 RS-232C connector.

• If GUI menu “Manual Setup” – “Option Setup” – “2Way Remote”is set to “Used”, you cannot use port 1

of the RS-232C connector for the external controller.

RS-232C connector

This connector is used for an external controller.

b

If you wish to control the AVR-5308CI from

an external controller using the RS-232C
connector, perform the operation below
beforehand.

q

Turn on the AVR-5308CI’s power.

w

Turn off the AVR-5308CI’s power from the

external controller.

e

Check that the AVR-5308CI is in the standby

mode.

Turning the Power On

(vpage 56)

Once Connections are Completed

Connections

AVR5308CIEU_100_初校作成中.indd 24

2008/05/26 9:38:57

Advertising