Denon AV SURROUND RECEIVER AVR-5308CI - Manual (Page 78)

Resetting the Microprocessor
Perform this procedure if the display is abnormal or if operations
cannot be performed.
All settings are reset when the microcomputer is reset. However,
the information in the Rhapsody account is not reset.
1
Turn off the power using <POWER> .
2 Press <POWER> while simultaneously pressing
<STANDARD> and <HOME THX CINEMA> .
3 Once the display starts flashing at intervals of about 1
second, release the two buttons.
If in step 3 the display does not flash at intervals of about 1 second,
start over from step 1.
Personal Memory Plus Function
This function sets the settings (input mode, surround mode,
HDMI output mode, Picture Adjust, Audio Delay etc.) last selected
for the individual input sources.
When you switch to an input source, the settings are automatically
set to the ones that were set the last time that input source was
used.
The surround parameters, tone control, room EQ settings and the
volumes of the different speakers are stored for the individual surround
modes.
Last Function Memory
This stores the settings as they were directly before the standby
mode was set.
When the power is turned back on, the settings are restored to as
they were directly before the standby mode was set.
Backup Memory
The various settings are backed up for about 1 week, even if the
power is turned off or the power cord is disconnected.
<POWER>
<STANDARD> <HOME THX CINEMA>
About the button names in these explanations
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit

Get
ting Star
ted
Connections
Set
up
Pla
ybac
k
Remot
e Contr
ol
Multi-Zone
Inf
or
mation
Tr
oubleshooting
AVR5308CIEU_100_初校作成中.indd 75 2008/05/26 9:42:52