Denon AV SURROUND RECEIVER AVR-5308CI User Manual
Page 39
b
If the access points are not detected automatically, use i to
select the “Manual” and press
ENTER
.
Setting becomes manual. For details, see “Manual settings”
(vpage 37, 38).
b
If the access points are repeat search, use i to select the
“Search” and press
ENTER
.
e
If there is an encryption setting for the access point you selected
in step w, enter same encryption key as used for the access
point. (If there is no encryption setting, proceed to step t.
1
Fitting a rod antenna (vpage 22).
b
If a LAN cable is connected, remove it.
2
Turn on the AVR-5308CI (vpage 56).
3
Set the access point at the GUI menu “Manual Setup”
– “Network Setup” – “Network Setup”.
When searching access points to connect automatically, refer to
“Automatic settings”.
When searching access points to connect manually, refer to
“Manual settings”.
n
Automatic settings
q
Select “Search” and press
ENTER
.
The access point you have set is displayed.
w
Use ui to select the access point, and then press
ENTER
.
e
Use ui p to input the address and press
ENTER
.
IP Address :
Set the IP address within the ranges shown below. The Network
Audio function cannot be used if other IP addresses are set.
CLASS A: 10.0.0.0 ~ 10.255.255.255
CLASS B: 172.16.0.0 ~ 172.31.255.255
CLASS C: 192.168.0.0 ~ 192.168.255.255
Subnet Mask :
When connecting an xDSL modem or terminal adapter directly
to the AVR-5308CI, input the subnet mask indicated in the
documentation supplied by your provider. Normally input
255.255.255.0.
Default Gateway :
When connected to a gateway (router), input its IP address.
Primary DNS Secondary DNS :
If there is only one DNS address indicated in the documentation
supplied by your provider, input it at “Primary DNS”. If there are
two or more DNS addresses, input the first one at “Secondary
DNS”.
r
Use i to select “Exit” and press
ENTER
.
Setup is complete.
b
When connecting to the network via a Proxy server, select “Proxy”
and press
ENTER
(vpage 38 “Proxy settings”).
Select when searching
access points again.
Wireless LAN settings
Use this procedure to configure the Wireless LAN settings.
w
Select the access point.
Example) DENON
Select when access
points cannot be searched
automatically.
q
Select “Search”.
r
Set only during
“WEP” in step w.
t
Select “Connection”.
e
Enter
encryption key.
Get
ting Star
ted
Connections
Set
up
Pla
ybac
k
Remot
e Contr
ol
Multi-Zone
Inf
or
mation
Tr
oubleshooting
AVR5308CIEU_100_初校作成中.indd 36
2008/05/26 9:40:40