Avery Dennison Monarch 932 Stacker - Manual (Page 6)

S t e p 1 - C o n n e c t t h e S t a c k e r
1. Locate the screw hole on the stacker mounting plate.
2. Attach the adjusting bracket to the stacker mounting plate using a
flanged screw as shown (do not tighten all the way).
3. Gently lift the stacker and center the guide tabs in the knife opening.
4. Set the stacker locating pins (on bottom of stacker) firmly in the
adjusting bracket locating hole and mounting plate slot.
5. Tighten the adjusting bracket flanged screw.
6. Connect the stacker cable to the knife.
1-2 Getting Started
Adjusting Bracket
Flanged Screw
Stacker Mounting
Plate
Locating Pin
Adjusting Bracket
Locating Hole
Mounting Plate
Slot
Guide Tab
Knife Opening