Avery Dennison SNAP 700 Stacker - Manual (Page 9)

Users Manual Model 500 Downstacker Customer Responsibility •••• 9
Customer Responsibility
Location of Stacker
The printer w/Stacker weighs approximately 50 Lbs (23 Kg) and requires a table of
sufficient quality and strength to handle this load while the system is operating.
AVERY DENNISON recommends an industrial type worktable having the
approximate dimensions of 72" wide to 30" deep to 32" high. Refer to Figure 2.
Figure 2 - Recommended Workstation Layout.
The location of the AVERY DENNISON 500 Printer should be based on human
factors. The Stacker should be located in an area that maintains optimum flow of
your product while providing for the operator’s comfort. AVERY DENNISON has
taken significant steps to ensure that the operator controls and operations are easily
accessible. This goal can only be met, however, if the printer is also located with
human factors in mind. These include the height of the Stacker, the space around the
Stacker and the accessibility to the printer.
While AVERY DENNISON has designed the system to be reasonably quiet, it is
recommended to locate the printer in an area where printing and cutting repetitious
noise is acceptable.