Aviosys 9223K-D - Manual (Page 16)

- 16-
Ref#9223KD0001
GPIO Configuration
Set I/O
The Set I/O configuration is where most of the live power control is done. From this panel the
user can directly turn off power, set timers and turn power back on.
PIN I/O
The Pin I/O column is the labels for the ports on the device.
By default the output ports are labeled as Out1, Out2, Out3, & Out 4. To rename these default
labels please see section “Definite I/O Name” for direction.
Note:
Please remember that you use normally open or normally closed the output control will either
create a open circuit or a closed circuit.
Device Status
Control Status Circuit
Normally Closed On Open
Normally Open On Closed
Control
The control section allows the user to directly turn on or turn off the device. Select the control that
you would like to execute and hit apply to apply the settings. This will turn the device on or off.
Time
The timer allows the user to set an amount of time before a control is activated. To do this, simply
enter the amount of delay time in seconds you would like the action to occur. Select the On or Off
and hit the apply button. When the timer has reached the time set it will execute your command.
For example if Port 1 is on and I would like to turn it off in 30 sections, the command may look
something like the following.
Note: The maximum number of seconds that can be set on the timer of the device is 9999.