Baby Lock Spirit (BLPY) Instruction and Reference Guide - Manual (Page 12)

NAMES OF MACHINE PARTS AND THEIR FUNCTIONS
B-10
Needle and Presser Foot Section
a Embroidery foot screw
Use the embroidery foot screw to hold the embroidery foot in
place. (page B-46)
b Embroidery foot
The embroidery foot helps control fabric flexibility for better
stitch consistency. Use the “W+” embroidery foot for most
machine embroidering. (page B-46)
c Bobbin cover
Open the bobbin cover to set the bobbin. (page B-36)
d Needle plate cover
Remove the needle plate cover to clean the race. (page E-22)
e Needle plate
f Needle bar thread guide
Pass the upper thread through the needle bar thread guide.
(page B-38)
g Needle clamp screw
Use the needle clamp screw to hold the needle in place.
(page B-49)
Embroidery Unit
a Carriage
The carriage moves the embroidery frame automatically when
embroidering. (page B-44)
b Release button (located under the embroidery unit)
Press the release button to remove the embroidery unit.
(page B-44)
c Embroidery frame holder
Insert the embroidery frame into the embroidery frame holder
to hold the frame in place. (page E-17)
d Frame-securing lever
Press the frame-securing lever down to secure the embroidery
frame. (page E-17)
e Embroidery unit connection
Insert the embroidery unit connection into the connection port
when attaching the embroidery unit. (page B-44)
CAUTION
• Before inserting or removing the embroidery
unit, turn the main power to OFF.
• After the embroidery frame is set in the frame
holder, be sure the frame-securing lever is
correctly lowered.