Datalogic Scanning 4410 - Manual (Page 10)

Powering the Falcon
8 Falcon
®
4400 Series with Windows
®
CE
Powering the Falcon
Getting Started
Before using the Falcon for the first time, you must install the battery pack
into the Falcon, then charge both the battery pack and the backup battery. See
Installing the Battery Pack on page
10 for instructions
.
Battery Pack
The battery pack in the Falcon is a 3.7 V, 2000
mAh Lithium Ion battery pack. You will be
alerted with a message dialog box when the bat-
tery pack reaches a low state.
After charging the first time, a complete charge
takes about four (4) hours depending on the bat-
Stylus
Use the stylus for navigation, the soft input panel (SIP), and to select items
on the touch screen. Place the stylus in the holder after use so you don’t lose
or misplace it. An optional Stylus Tether is available for all models.
Figure 10 ,
page 20
Feature Function/Description
More
Information
CAUTION
You must charge the battery pack and backup battery in a dock or with a power
cable prior to your first use of the Falcon. The initial charge time is approximately
24 hours. See
Charging the Batteries on page 13 for more information.
3.7V
Li-ion
CAUTION: Battery can explode, leak or catch
fire if exposed to high temperature, water or fire.
Do not short circuit, open or disassemble battery.
Recycle or dispose of properly.
2000mAh
5-1764
Product of USA
U S