Datalogic Scanning 4410 - Manual (Page 11)

Getting Started
Quick Reference Guide 9
tery pack’s state and the recharging method. A sample battery pack label is
shown at the right.
Power Supply
Use only the authorized power supplies, battery packs, chargers, and docks
supplied by your Datalogic reseller. The use of any other power supplies can
damage the Falcon and void your warranty.
CAUTION
You must charge the battery pack and backup battery in a dock or with a power
cable prior to your first use of the Falcon. The initial charge time is approximately
24 hours.
If you remove the battery pack or it fails, there is a 30 minute window in which to
insert a charged battery pack before the backup battery fails. If your backup bat-
tery fails, the contents of the RAM memory will be lost. If your back-up battery is
less than fully charged, there is a proportionally smaller window of time available.
Usage time will be reduced, also.
Always charge the battery pack within the temperature range of 32°–113°F (0°–
45°C).
WARNING
Lithium-ion battery packs may get hot, explode, ignite, or/and cause serious injury if
exposed to abusive conditions.
• Do not place the battery in or near fire, direct sunlight, or other high tempera-
ture locations, or heat the battery.
• Do not install the battery backwards so the polarity is reversed.
• Do not connect the positive terminal and negative terminal of the battery to
each other with any metal object (such as wire or coin).
• Do not expose the battery to liquids, or allow the battery to get wet.
• Do not disassemble, modify, or pierce the battery. The battery contains safety
and protection devices, which, if damaged, may cause the battery to generate
heat, explode or ignite.
In the event the battery leaks and the fluid gets into your eye, do not rub the eye.
Rinse well with water and immediately seek medical care. If left untreated, the battery
fluid could cause damage to the eye.
Datalogic recommends annual replacement of rechargeable battery packs to
ensure maximum performance.