BECKHOFF AX2500 - Manual (Page 51)

8.13.2 Sine encoder 5V with BISS (X2)
Connection of a single- or multiturn sine-cosine encoder (5V) with BISS interface as feed-
back (from firmware revision 6.68). During start-up of the servo amplifier the parameters
stored in the encoder eeprom are uploaded, after that phase only the sine/cosine signals
are used.
The thermostat contact in the motor is connected via the encoder cable to X2 and
evaluated there. All signals are connected using our pre-assembled encoder connection
cable.
If cable lengths of more than 50m are planned, please consult our customer service.
Frequency limit (sin, cos): 350 kHz
FBTYPE: 20
AX2500 Product Manual 51
BECKHOFF
06/2007
Electrical Installation
AX2500