BECKHOFF AX2500 - Manual (Page 82)

9.3.6 Feedback
Press function key F12 (disable) before
changing feedback parameters.
Feedback Type:
Select the feedback type used.
Leave all other fields unchanged.
If Software Enable is active, a warning ap-
pears. The configuration change cannot be
performed.
Click OK on the warnings, press F12 (SW
disable) and start the Feedback procedure
again.
If everything was ok, the same procedure
(parameter upload) that has been described
for the motor selection starts.
If you click "Yes", the parameters are saved
in the EEPROM and the amplifier makes a
coldstart (reset). This takes some seconds.
82 AX2500 Product Manual
Setup
06/2007
BECKHOFF