Bolide BN1008 - iCube User Manual
Page 36
32
PRODUCT USER MANUAL
BN1008 - iCube
means selected area; click
button, then press and drag cursor to delete detection
area; click “Clear” button to clear all detection areas, click “Save” button to save the setting;
click “Back” button to exit current interface.
Step4: Motion detection configuration can be copied to the other channel. Click
“Copy” button to copy the specified channel settings to other channel or all channels.
Step5: Click “Default” button to
restore the default setting; click “Apply” button to
save the setting.
3.5.5.3 Video Loss
Enter into “Config”àRemote ConfigàAlarmàVideo Loss. The setup steps are similar
to sensor alarm; user can refer to Chapter 3.5.5.1 Sensor for more details.
3.5.5.4 Other Alarm
Enter into “Config”àRemote ConfigàAlarmàOther Alarm; refer to Fig 3-33:
Fig 3-33
Step1: Select the alarm type, and then set the trigger options. When the selected
alarm is triggered, it will trigger the relevant alarm.
Select “HDD Full”: set a threshold value for remaining HDD space. If the threshold
value is reached, the system will display prompt.
Select “IP Address Conflict”: when IP address conflict with other network device’s IP
address on the same segment, the system will trigger alarm prompt if you have set the
trigger options.
Select “Network Unconnected”: the system will trigger alarm prompt if you have set
the trigger options when disconnected from the network.
Step2: Click “Default” button to
restore the default setting; click “Apply” button to
save the setting.