Bronkhorst IN-FLOW - Manual (Page 5)

BRONKHORST HIGH-TECH B.V.
BUS/digital operation
For this procedure: See description for specific fieldbus
Send a setpoint to the instrument and check the
measured value
Let the instrument warm-up for 30 minutes for best
accuracy
Your Mass Flow/Pressure Meter/Controller is now
ready for operation.
! Caution
Operation via fieldbus is done by means of a flatconductor
cable connected with the main PC board.
Although all functionality is possible by means of RS232
and the switch on top of the instrument, it is important
that care should be taken when removing the upper part
of the housing.