B3r,c,a,h,p (code 39), H is the letter y – Compuprint 6314 CZL User Manual
Page 20
CZL – Programmer Manual
20
Regardless, the number of characters coded by the 2/5 Interleaved bar-code must be even: if it is
not, a zero will be added to the most significant position (on the left).
r is a letter that determines the rotation of the bar-code. It can assume the following values:
N: normal rotation (0°)
R: rotated (90°)
I: inverted (180°)
B: bottom up rotation (270°)
a is a whole number between 1 and 9999
and expresses the height of the bar-code expressed in
dots
h is the letter Y
55
if printing of the human readable field is desired; if not, it is the letter N.
p is the letter Y (yes) or N
56
(no). If the human readable field is desired (when h=Y), it is possible to
position it above (p=Y) or below (p=N).
c is the letter Y (yes) or N
57
(no). Y if the check digit is to be added, N if not.
^B3r,c,a,h,p (Code 39)
This code accepts numerals and upper-case letters, and its length is variable with optional check
digit; it accepts ratios from 2 to 3 (see table 8 on page 49).
The command accepts up to 100 characters, but the limit is determined by the width of the label (or
the maximum length of the printing area if the bar-code is rotated by 90°/270°
) together with the
ratio set by the ^BY command on page 19. In other words, if the bar-code spills over the boundaries
of the printing area due its excessive size (determined by the number of characters to be coded
and/or by the ratio), it could be wrongly interpreted by the reader. In any event, the part that is
included in the useful printing area is printed.
The two start and stop asterisks provided by Code 39 are automatically added.
r is a letter that determines the rotation of the bar-code. It can assume the following values:
N: normal rotation (0°)
R: rotated (90°)
I: inverted (180°)
B: bottom up rotation (270°)
c is the letter Y (yes) or N
(no). Y if the check-digit is to be added, N if not.
a is a whole number between 1 and 9999
and expresses the height of the bar-code, expressed in
dots
h is the letter Y
63
if printing of the human readable field is desired, N if not.
52
The default value is that of the last ^FW command (page 10) received.
53
The default value is that of the last ^BY command (page 19) received.
54
See note 5 on page 9.
55
Default value.
56
Default value.
57
Default value.
58
The maximum length of the printing area is in turn limited by the available RAM. Please refer to the User Manual.
59
The default value is that of the last ^FW command (page 10) received.
60
Default value.
61
The default value is that of the last ^BY command (page 19) received.
62
See note 5 on page 9.
63
Default value.