Compuprint 6314 CZL - Manual (Page 44)

CZL – Programmer Manual
44
<STZ>mmm,n,o,p,q,r,s,t,uuuu,v,www<ETX><CR><LF>
mmm: is a base 8 number that describes the communications parameters of the serial port. mmm is
the octal representation of the binary number m
8
m
7
m
6
m
5
m
4
m
3
m
2
m
1
m
0
.
m
8
: is always 0. Reserved.
m
7
indicates the type of form in use. With a reference marker (gap, black tick mark, or hole)
when it is low (0), continuous form when it is high (1).
m
6
is always 0. Reserved.
m
5
is always 0. Reserved.
m
4
, m
3
, m
2
, m
1
, are not used and thus always 0.
m
0
indicates the printing mode. Direct thermal transfer when it is low (0), thermal transfer when
it is high (1).
n: is always 0. Reserved.
o: is always 0. Reserved.
p: is high (1) when the ribbon is out. 0 in other cases.
r: is always 0. Reserved.
s: is always 6. Reserved.
t: is 1 when there is a label under the present sensor. 0 in other cases.
uuuu: is the whole number of four digits that indicates the number of labels in the current batch that
remain to be printed.
v: is always 1. Reserved.
www: is the whole number of 3 digits that indicates the number of graphic images in the RAM
memory.
The format of the third string is:
<STZ>xxxx,y<ETX><CR><LF>
xxxx: is always 0000. Reserved for future uses.
y: is always 0. Reserved for future uses.
~JR (Power On Reset)
This command has exactly the same effects as shutting off and then turning on the machine. All
registers are reset, the RAM is deleted, etc.
3.2.2 Calibration and setting commands
~JC (Set Media Sensor Calibration)
This command forces adjustments in the sensitivity of the paper sensor via software (please refer to
the User Manual) and measures the length of the label in use so that it is properly lined up under the
head.