Comtech EF Data CDM-500 - Manual (Page 41)

Front Panel Operation CDM-500 Closed Network Satellite Modem
6–12 Rev. 1.3
6.5.27 (CONFIG, FRAME, FRAMED, ON) EDMAC SLAVE
EDIT THIS UNIT'S ADDRESS
0245 (SEE HANDBOOK)(ENT)
Edit the address of this SLAVE unit. Select the digit to be edited, using the LEFT/RIGHT
arrow keys. Change the value of the digit using the UP/DOWN arrow keys. Press Enter.
The valid range of addresses is from 1 to 9999, although ‘base 10' values will be
automatically skipped.
Remember that this is a unit which is intended to be located at the distant-end of a link,
and will therefore be under the control of a MASTER at the other end. This is the
equivalent of putting the unit into Remote Control mode - no local control is possible.
6.5.28 (CONFIG) INTFC (Interface)
Select RS422 (EIA 530), V.35, or RS232 (synchronous), using the LEFT/RIGHT arrow
keys, then press ENTER.
6.5.29 (CONFIG) REMCONT (Remote control)
DATA INTERFACE: RS422
V.35 SYNC-RS232 (ENTER)
Select LOCAL or REMOTE using the LEFT/RIGHT arrow keys, then press Enter.
6.5.30 (CONFIG, LOCAL)
If LOCAL is selected then remote control will be disabled. Remote monitoring is still
possible.
6.5.31 (CONFIG, REMOTE)
SELECT REMOTE CONTROL:
LOCAL REMOTE (PRESS ENT)
If REMOTE is selected then the following sub-menus will be displayed:
If the unit has not been defined as an EDMAC SLAVE then:
REMOTE CONTROL: BAUDRATE
INTERFACE (PRESS ENTER)
Select BAUDRATE or INTERFACE, using the LEFT/RIGHT arrow keys, then press
Enter.