Comtech EF Data CDM-500 User Manual
Page 8
CDM-500 Satellite Modem
Preface
Rev. 1.3
iii
6.5.14
(CONFIG, RX) DATA (Data Rate) ................................................................................................... 6–8
6.5.15
(CONFIG, RX) FEC (Forward Error Correction) .............................................................................. 6–8
6.5.16
(CONFIG, RX) ACQ (Acquisition sweep range) .............................................................................. 6–9
6.5.17
(CONFIG, RX) DESCRAM (Descrambler)....................................................................................... 6–9
6.5.18
(CONFIG, RX) CLK (Clocking)......................................................................................................... 6–9
6.5.19
(CONFIG, RX) BUF (Buffer size).................................................................................................... 6–10
6.5.20
(CONFIG, RX) RSI (Receive spectral inversion) ............................................................................. 6–10
6.5.21
(CONFIG, RX) Eb/No (Eb/No Alarm) ............................................................................................. 6–10
6.5.22
(CONFIG) FRAME (Framing Mode) ............................................................................................... 6–10
6.5.23
(CONFIG, FRAME) TRANSPARENT ............................................................................................ 6–10
6.5.24
(CONFIG, FRAME) FRAMED ........................................................................................................ 6–11
6.5.25
(CONFIG, FRAME, FRAMED) EDMAC-ON................................................................................. 6–11
6.5.26
(CONFIG, FRAME, FRAMED, ON) EDMAC MASTER............................................................... 6–11
6.5.27
(CONFIG, FRAME, FRAMED, ON) EDMAC SLAVE .................................................................. 6–12
6.5.28
(CONFIG) INTFC (Interface) ........................................................................................................... 6–12
6.5.29
(CONFIG) REMCONT (Remote control)......................................................................................... 6–12
6.5.30
(CONFIG, LOCAL) .......................................................................................................................... 6–12
6.5.31
(CONFIG, REMOTE)....................................................................................................................... 6–12
6.5.32
(CONFIG, REMOTE, BAUD).......................................................................................................... 6–13
6.5.33
(CONFIG, REMOTE, INTFC) ......................................................................................................... 6–13
6.5.34
(CONFIG, REM, INTFC, ADDR) RS232 BUS ADDRESS ........................................................... 6–13
6.5.35
(CONFIG, REM, INTFC, ADDR) RS485 BUS ADDRESS: .......................................................... 6–13
6.5.36
(CONFIG) MASK (Alarm mask)..................................................................................................... 6–13
6.5.37
(CONFIG, MASK) AGC ................................................................................................................. 6–14
6.5.38
(CONFIG, MASK) Eb/No ................................................................................................................ 6–14
6.5.39
(CONFIG, MASK) RX-AIS ............................................................................................................. 6–14
6.5.40
(CONFIG, MASK) BUF-SLIP (Buffer slip)..................................................................................... 6–14
6.5.41
(CONFIG, MASK) TX-AIS.............................................................................................................. 6–15
6.5.42
(CONFIG) IMPED (IF impedance) .................................................................................................. 6–15
6.6
TEST ........................................................................................................................................................... 6–16
6.7
INFO (Information) ................................................................................................................................... 6–17
6.7.1
(INFO) ID (Circuit ID) .......................................................................................................................... 6–17
6.7.2
(INFO) TX (Transmit information) ....................................................................................................... 6–17
6.7.3
(INFO) RX (Receive information) ........................................................................................................ 6–17
6.7.4
(INFO) BUFF (Buffer information) ...................................................................................................... 6–18
6.7.5
(INFO) EDMAC (Framing and EDMAC information)......................................................................... 6–18
6.7.6
(INFO) REMCONT (Remote Control information).............................................................................. 6–18
6.7.7
(INFO) MASK (Alarm mask information)............................................................................................ 6–18
6.7.8
(INFO) MISC (Miscellaneous information) .......................................................................................... 6–19
6.8
MONIT (Monitor) ...................................................................................................................................... 6–20
6.8.1
(MONIT) ALARMS.............................................................................................................................. 6–20
6.8.2
(MON, ALARMS) UNIT (Unit alarms)................................................................................................ 6–20
6.8.3
(MON, ALARMS) RECEIVE (Receive alarms)................................................................................... 6–20
6.8.4
(MON, ALARMS) TRANSMIT (Transmit alarms).............................................................................. 6–20
6.8.5
(MONIT) STORED EVENTS............................................................................................................... 6–21
6.8.6
(MON, EVENTS) VIEW ...................................................................................................................... 6–21
6.8.7
(MONIT) RX-PARAMS (Receive Parameters) .................................................................................... 6–22
6.9
STORE/LD (Store/Load) ........................................................................................................................... 6–23
6.9.1
(STORE/LD) STORE............................................................................................................................ 6–23
6.9.2
(STO/LD) LOAD .................................................................................................................................. 6–23