Comtech EF Data SNM-1001L - Manual (Page 144)

SNM-1001L Satellite Modem Revision 1
Front Panel Operation MN/SNM1001L.IOM
4–80
FUNCTION SELECT: UTILITY: SYSTEM: OPERATION MODE
OPERATION MODE
DUPLEX
Programs the modem for DUPLEX, TX ONLY, or RX ONLY operation.
Note: When TX ONLY or RX ONLY is selected, the appropriate faults are masked from the Faults
and Stored Faults menus.
FUNCTION SELECT: UTILITY: SYSTEM: YEAR DISPLAY
YEAR DISPLAY
2 - DIGIT
Displays the year in either 2-digits or 4-digits.
To change the remote address, press <ENTER>. Press [
↑] or [↓] to make the selection. Press
<ENTER> to execute the change.
FUNCTION SELECT: UTILITY: SYSTEM: TEST MODE STATUS
TEST MODE STATUS
_ _ _ _ _ _ _ _
Test mode status indicator. The following modem test points are listed and display a “+” when a
test mode is active:
• RS CORR OFF
• INTRFC LOOP BACK
• B-BAND LOOP BACK
• CARRIER
MODE
• IF LOOP BACK
To view the test modes, press <ENTER>. Press [
↑] or [↓] to make the selection.