Configuration code – card #3, Utility factory set-up, 8 function select: utility: factory set-up – Comtech EF Data SNM-1001L User Manual
Page 158
SNM-1001L Satellite Modem
Revision 1
Front Panel Operation
MN/SNM1001L.IOM
4–94
FUNCTION SELECT: MODEM TYPE:
CONFIGURATION CODE – CARD #3 (CONDITIONAL)
CONFIGURATION
CODE – CARD #3
Comtech EF Data-supplied code. Press <ENTER>
IMPORTANT
This menu appears only if the Overhead card is installed.
1)AAAAAAAAAA
2)AAAAAAAAAA
On entry, the current configuration code is displayed with the flashing cursor on the first
character. Press [
←
] or [
→
] to move the flashing cursor. Press [
↑
] or [
↓
] to increment or decrement
the digit at the flashing cursor. Press <ENTER>
to execute the change.
Entering this code enables the corresponding modem option. To purchase an option, contact an
Comtech EF Data marketing representative for more information.
4.3.6.8
FUNCTION SELECT: UTILITY: FACTORY SET-UP
UTILITY
FACTORY SET-UP
CAUTION
This configuration is used for factory alignment. Unauthorized persons
should not change factory setup. Doing so can cause modem failure.