Daktronics AB-1600-1.5,2.5 User Manual
Page 63
Maintenance & Troubleshooting
4-19
The DS1-DS8 indicator LEDs on the receiver board must all be ON if a fan control expander is used
with this display. This indicates the fan control expander board is receiving no fan failure notices from
the fan controllers.
If a fan controller expander is not used each LED corresponds to a fan controller within the display.
All must be ON for the display to operate.
If the display is out of use for 30 minutes, the receiver board sends a signal, either directly or through
the fan control expander board, to the fan controllers to turn off the fans. This is designed to extend the
life of the fans/cooling system and electronics of the display. The fans will automatically turn back on
when the display is put back in use.
The following tables list the functions of some of the connectors on the receiver board and output
cards, as well as the meanings of the diagnostic LEDs.
Receiver Board Connectors
Connector
Function
J1 (Fans)
Input from either fan controllers or fan control expander bd.
J4 (Power)
Power input from power supply
J5 (Data In)
Fiber Optic Input from controller or other equipment
Receiver Board DS1-DS8 LEDs WITHOUT Fan Control Expander Board
LED
Function
DS1
ON if fan controller number 1 reports all fans good
DS2
ON if fan controller number 2 reports all fans good
DS3
ON if fan controller number 3 reports all fans good
DS4
ON if fan controller number 4 reports all fans good
DS5
ON if fan controller number 5 reports all fans good
DS6
ON if fan controller number 6 reports all fans good
DS7
ON if fan controller number 7 reports all fans good
DS8
ON if fan controller number 8 reports all fans good
Receiver Board DS1-DS8 LEDs WITH Fan Control Expander Board
LED
Function
DS1 & DS2
ON if fan controller expander board input J2 reports all fan
controllers good.
DS3 & DS4
ON if fan controller expander board input J3 reports all fan
controllers good.
DS5 & DS6
ON if fan controller expander board input J4 reports all fan
controllers good.
DS7 & DS8
ON if fan controller expander board input J5 reports all fan
controllers good.
Receiver Board DS10-DS19 LED Block
LED
Function
DS10
N.C.
DS11
Processor Initialization Complete
DS12
EPLD Configuration Complete