DFI NP100-N16C - Manual (Page 34)

34
2
Hardware Installation
1 1
USB Ports
USB allows data exchange between your computer and a wide range of simulta-
neously accessible external Plug and Play peripherals.
The system board is equipped with four onboard USB 2.0/1.1 ports. The USB 4-5
and USB 6-7 connectors allow you to connect 4 additional USB 2.0/1.1 ports. The
additional USB ports may be mounted on a card-edge bracket. Install the card-
edge bracket to an available slot at the rear of the system chassis then insert the
USB port cables to a connector.
BIOS Setting
Configure the onboard USB in the Integrated Peripherals submenu (“USB Device
Setting” section) of the BIOS. Refer to chapter 3 for more information.
Driver Installation
You may need to install the proper drivers in your operating system to use the
USB device. Refer to your operating system’s manual or documentation for more
information.
USB 0
USB 1
USB 2
USB 3
USB 4-5
USB 6-7
1
VCC
-Data
+Data
GND
K
ey
VCC -Data +Data GND N.
C.
2 10
9