DFI NP100-N16C - Manual (Page 81)

81
3
BIOS Setup
PnP/PCI Configurations
This section shows how to configure the PCI bus system. It covers some very
technical items and it is strongly recommended that only experienced users
should make any changes to the default settings.
Init Display First
Onboard
When the system boots, it will first initialize the onboard VGA.
PCI Slot
When the system boots, it will first initialize PCI.
Reset Configuration Data
Enabled
The BIOS will reset the Extended System Configuration Data (ESCD) once
automatically. It will then recreate a new set of configuration data.
Disabled
The BIOS will not reset the configuration data.
Resources Controlled By
The Award Plug and Play BIOS has the capability to automatically configure all of
the boot and Plug and Play compatible devices.
Auto(ESCD)
The system will automatically detect the settings for you.
Manual
Choose the specific IRQ resources in the “IRQ Resources” field.
Phoenix - AwardBIOS CMOS Setup Utility
PnP/PCI Configurations
Item Help
Menu Level

↑↓→← : Move Enter: Select F1: General Help +/-/PU/PD: Value F10: Save ESC: Exit
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Init Display First
Reset Configuration Data
Resources Controlled By
x IRQ Resources
PCI/VGA Palette Snoop
** PCI Express Relative Items **
Maximum Payload Size
Onboard
Disabled
Auto(ESCD)
Press Enter
Disabled
128
The settings on the screen are for reference only. Your version may not be identical to
this one.