DFI NP100-N16C - Manual (Page 60)

60
3
BIOS Setup
Halt On
This field determines whether the system will stop if an error is detected during
power up. The default setting is All Errors.
No Errors
The system boot will not stop for any errors detected.
All Errors
The system boot will stop whenever the BIOS detects a non-fatal error.
All, But Keyboard
The system boot will not stop for a keyboard error; it will stop for all other
errors.
All, But Diskette
The system boot will not stop for a disk error; it will stop for all other errors.
All, But Disk/Key
The system boot will not stop for a disk or keyboard error; it will stop for all
other errors.
Base Memory
Displays the amount of base (or conventional) memory installed in the system.
The value of the base memory is typically 512K for systems with 512K memory
installed on the motherboard or 640K for systems with 640K or more memory
installed on the motherboard.
Extended Memory
Displays the amount of extended memory detected during boot-up.
Total Memory
Displays the total memory available in the system.