Digital Alert Systems DASAMS - Manual (Page 25)

Digital Alert Systems
AMS Installation /Operation & Integration Guide
Revision 1.1 Page 25 of 28
BTI Weather Alerts
Stations using BTI for weather alerts will get the new Transmission EW903 (see
the yellow highlight in
Figure 20 ). To produce text this may run stand alone, or
BTI can program it into the current broadcast weather alert transmission.
1. To configure the EW903 weather transmission, from the Transmission
Status screen click the Configure button
Figure 20. Transmission Status screen showing weather alert job EW903
2. On the Configure Job EW903 screen set the number of cycles to run the
transmission. Typically this has a value of 2 as shown in Figure 21 .
Figure 21. BTI Configure Job EW903 screen with number of Cycles highlighted.
3. Click Save then Close
4. After returning to the Transmission Status screen click the Content
button.
5. In the Maintain Transmissions page click Customize to enter the
Advanced Transmission parameters
(Continued)
Figure 22 BTI Maintain Transmissions screen