DR Power Z-Mower 19.5 HP Versa-Pro - Manual (Page 19)

CONTACT US AT www.DRPower.com or CALL TOLL FREE 1-800-DR-OWNER 15
Adding Oil and Gasoline
TO GET AN ACCURATE READING WHEN CHECKING THE OIL LEVEL:
⇒ THE MACHINE SHOULD BE ON A LEVEL SURFACE.
⇒ THE DIPSTICK SHOULD BE SCREWED DOWN ON BRIGGS & STRATTON ENGINES.
Tip: To avoid confusion, we recommend leaving the caps ON the Fuel and Oil Fills until you are ready to
pour either gasoline or oil into the correct Fill.
NOTE: Use only SAE 30 High Detergent oil. Other types of oil could cause problems with the operation of your
machine. Please refer to your Engine Owner’s Manual for detailed oil information.
Approximate Engine Oil Required
Briggs & Stratton – 19.5 HP, OHV, AVS, ELS 48 oz. (1.42 L)
Briggs & Stratton – 22.0 HP, OHV, AVS, ELS 64 oz. (1.89 L)
1. Place the machine on a level surface and initially add 32 oz. of SAE 30 High Detergent oil
(recommended by the Engine Manufacturer) into the Oil Fill (Figure 2) and wait one minute for the oil
to settle.
2. Check the Dipstick and continue adding a few ounces of oil at a time, rechecking the Dipstick until the
oil reaches the fill mark. Be careful not to overfill.
3. Fill the Fuel Tank to not more than 1/4" from the bottom of the Fill Neck with fresh, unleaded gas.
The Fuel Tank contains five (5) gallons. See the Engine Owner’s Manual for more information.
Check the Tire Pressure
There should be 10 psi in all tires.
NOTE: Do not fill the tires to the maximum pressure indicated on the side of the tires.
Fuel Fill
Oil Fill
Figure 2