ESI MaXiO 032 - Manual (Page 17)

MaXiO series System Manual
17
removing the PCI/PCIe slot faceplate
Put the MaXiO PCI/PCIe host card into the slot and make sure it is placed in correctly.
Insert the card into the slot and then tighten the screw. Then you can close the computer
case.
MaXiO PCI/PCIe host card installed in a PCI/PCIe slot
4. You can finish the installation of the PCI/PCIe host card by connecting the M.D.I breakout
cable to the M.D.I port (if you use no other M.D.I compatible device like the MaXiO 032
breakout box).
3.2 EX8000 connection
After the MaXiO PCI host card is installed in the PCI slot, you should connect EX8000 to the card
using the supplied standard IEEE1394/FireWire cable.
Start by connecting the EX8000 with the E.D.I In connector on EX8000 with the first E.D.I port on
the MaXiO PCI/PCIe host card as shown on the picture below. If you have several EX8000 units,
connect the second unit to the second E.D.I port and so on.