ESI MaXiO 032 - Manual (Page 30)

MaXiO series System Manual
30
Please note that when you select the analog or S/PDIF input channels, the input signals from that
specific channel pair from the E.D.I or M.D.I multichannel ports are no longer used.
Please keep in mind that the M.D.I analog and S/PDIF input selection buttons should not be used if
you do not want to use the S/PDIF or analog input signals from the device or cable connected to the
M.D.I port – use them only when you are using the M.D.I breakout cable (S/PDIF inputs, no analog
inputs) or a M.D.I extension like the MaXiO 032 breakout box (both S/PDIF and analog inputs).
5.2.1 Input signal path block diagram
S
IN PORT1
1/2 3/4 5/6 7/8
S/PDIF IN
S S
A A A
z REC DMA
1/2/3/4/5/6/7/8 ch.
Onboard S/PDIF Input
Ch. selection (CH3/4)
Onboard Analog Input
Ch. selection (CH1/2)
X X
X X
S
A ANALOG IN
IN PORT2
X X
1/2 3/4 5/6 7/8
z REC DMA
9/10/11/12/13/14/15/16 ch.
8 ch. audio stream
E.D.I 1
M.D.I [1/4]
Mono MIX
Monitor ON
Monitor OFF
M.D.I Connector
E.D.I Connector #1
9/10 11/12 13/14 15/16
same structure
as port 1
E.D.I 2
E.D.I Connector #2
MASTER OUT
To PC
To Selected output Channel,
analog out and S/PDIF out
IN PORT3
IN PORT4
OUT PORT 1
OUT PORT 2
OUT PORT 3
OUT PORT 4
Internal 64ch 32bit Digital Mixer
Total 32ch DMA
at (max.) 192kHz
X X
M.D.I [2/4]
M.D.I [3/4]
M.D.I [4/4]