ESI MaXiO 032 - Manual (Page 9)

MaXiO series System Manual
9
can be amplified with 48dB maximum, line level signals with up to 30dB.
Analog Input / Output Level Meter
The two level meters indicate the signal level for the analog inputs and outputs. The level meter
on the left shows the input signal; the level meter on the right shows the output signal of the
corresponding channel. A range from 0dB to 60dB in 10 dB-steps is displayed.
2.2.2 Front Panel Power Section
Power Indicator LED
Power Switch
Phantom Power Switch
+48V DC phantom power (for balanced condenser microphones) will be
supplied via every XLR input connector when this button is enabled.
Note that this affects only those input channels that are set to receive
microphone signals (check
).
· Before you turn on the phantom power switch, you must make sure to connect your
microphones to the XLR inputs (with balanced cables).
· After you have turned on the phantom power switch, you should not connect or
disconnect a microphone to any of the input connectors.
2.2.3 Back Panel Power Section
AC IN
EX8000 needs external AC power. It supports 100~240V AC (free voltage). There
is a spare fuse (5X20mm Glass Fuse) below the connector.
2.2.4 Front Panel Clock & Control Section
Clock Source Indicator
Displays the current clock source of EX8000:
- Internal:
EX8000 uses its internal clock.
- External: EX8000 works with the clock from the Word Clock input.
- Digital In: EX8000 works with the clock supplied from the AES/EBU,
S/PDIF or ADAT input.
- E.D.I: EX8000 works with the clock from the MaXiO PCI/PCIe
host card.
Clock Frequency Indicator
Displays the current sample rate of EX8000.
Clock Select Button 1
When EX8000 is working in stand alone mode, you can choose the
clock source with this button (Internal, External, Digital In). This
function is not available when EX8000 is connected to the MaXiO
5
6
7
22
11
12
9
10
!
CAUTION
4
5
6
7
22
9
10
11
2