ESI Waveterminal U24 - Manual (Page 59)

59
SPECIFICATIONS
1. Input LEVEL
- -10dBV Unbalance : -10dBV Nominal, +6.5dBV Max
2. Output LEVEL -
-10dBV Unbalance : -10dBV Nominal, +3.0dBV Max
3. Input Impedance -
Unbalanced Mode 10K
4. Output Impedance -
Unbalanced Mode 100
5. Analog Input Gain/Attenuation
- Analog 0dB ~ 18dB, 0.5dB Step Size
Digital -72dB ~ 0dB, About 0.5dB
Step Size
6. Analog Output Gain/Attenuation
- Digital -72dB ~ 0dB, About 0.5dB Step Size
7. Sample Rate -
32KHz,44.1KHz,48KHz
8. A/D Spec
1) Type -
AKM Semiconductor, 24Bit, 64xOversampling
2) Dynamic Range - 100dB A-Weighted, AT -60dBFS measurement method
3) Signal-to-Noise Ratio - 100dB A-Weighted
4) S/(N+D) Ratio - 90dB, AT -0.5dBFS measurement method
5) Inter channel Gain Mismatch - Typical:0.2dB, Max:0.5dB
6) Frequency response -
0 ~ 20KHz (FS=44.1KHz)
9. D/A Spec
1) Type -
AKM Semiconductor, 24Bit, 128x Oversampling
2) Dynamic Range - 110dB A-Weighted AT -60dBFS measurement method
3) Signal-to-Noise Ratio - 110dB A-Weighted
4) S/(N+D) Ratio - 94dB, AT -0.5dBFS measurement method
5) Inter channel Gain Mismatch - Typical:0.2dB, Max:0.5dB
6) Frequency response -
0 ~ 20KHz (FS=44.1KHz)
10. Digital I/O Spec
1) Type -
Crystal Semiconductor
24Bit Digital Audio I/O with Sample rate Converter
2) Format - IEC60958,AES3,S/PDIF
3) Sample Rate - 32KHz, 44.1KHz, 48KHz
4) Resolution - 24Bits
5) Sample Rate Converter - 128dB Dynamic Range
1:3 & 3:1 Maximum input to output sample rate ratio