Assembly and installation (cont.) – Fire Magic DC430-XXR-75SM Island Enclosure User Manual

Page 7

Advertising

REV 6 - 1409101305

L-C2-306

ASSEMBLY AND INSTALLATION - STEP BY STEP

CAUTION: Island components are heavy. CAREFULLY

handle all components during assembly.

Note: A DC430 grill island is depicted here. Your assembly

may slightly vary depending on model selected.

Island Base

Important: DO NOT fully tighten bolts until the island

base is leveled and squared. Hand tighten
until instructed to fully tighten.

1. Locate the island pieces in an appropriate location (refer

back to the LOCATION section if needed).

2. Carefully lay the front wall down and attach the levelers.

Repeat for the rear wall and two side walls. See Fig. 7-1.

Important: The levelers are required for ventilation and

leveling purposes.

3. Orient the rear wall and left wall as shown. Carefully

align the pilot holes, and insert the hardware in the order
shown. Hand tighten only. See Fig. 7-2.

Note: DO NOT fully tighten any bolts until all 4 walls are

set and the top surface is even.

4. Orient the right wall and repeat the hardware installation

process for the bottom hardware fi rst. Ensure the top
pilot holes are aligned.

An outlet box assembly is provided and requires
installation. Assemble the box as shown, then use the
hardware to secure both the top of the right wall and the
outlet box in place. See Fig. 7-3 and 7-4.

Note: Covers are provided for any outlets that will not be

used (if applicable).

Fig. 7-1 Attach levelers

Fig. 7-2 Assemble rear and left wall

Fig. 7-3 Assemble right wall and outlet box

Fig. 7-4 Right wall and outlet box installed

Attach levelers to bottom of all 4 walls

Hardware:

Bolts x 2

Nuts x 2

Washers x 4

ASSEMBLY AND INSTALLATION (Cont.)

(hand tighten)

DC430
shown

[covers are

provided for any

outlets that will

not be used]