Fire Magic DC430-XXR-75SM Island Enclosure - Manual (Page 9)

9 REV 6 - 1409101305 L-C2-306
Install Drawer and/or Door(s)
The drawers/doors for your island are purchased separately.
Review the instructions provided with your accessories. See
Fig. 9-1 for install locations.
Brackets are provided for ease of installation in this island.
Follow the steps below.
1. Insert your door/drawer completely into the appropriate
opening. Ensure it is fl ush against the exterior wall (see
Fig. 9-1 and Fig. 9-2, A).
2. The door will have 2-4 oblong cutouts (or round holes)
on both the top and bottom of its frame. Insert a bracket
where a cutout exists, below the frame. See Fig. 9-2, B.
3. While squeezing the rear of the bracket and the front of
the door frame fi rmly against the concrete wall, insert
a hex screw and tighten with the power drill and 5/16"
hex driver (see Fig. 9-2, C). DO NOT OVERTIGHTEN
Note: Certain models may require a second person to hold
the bracket against the concrete wall from within the
island enclosure.
4. Repeat this process for the remaining brackets and the
second door/drawer in the island.
Note: Only the cutouts in the top and bottom of the frames
require brackets.
Alternatively, the doors/drawers may be installed by fasten-
ing them into the island using #8 x 1" concrete screws (not
provided). DO NOT OVERTIGHTEN.
Use a power drill and a 1 /
8
" bit to drill all pilot holes needed
(through the frame pilot holes). Then install the screws as
shown in Fig. 9-3.
Fig. 9-1 Door / drawer install locations
Fig. 9-3 Alternate door/drawer install method
ASSEMBLY AND INSTALLATION (Cont.)
Use provided brackets
to install, see Fig. 9-2
for details.
Fig. 9-2 Door / drawer install detail
Under grill door: 4-8 brackets
End door: 4 brackets
A
B
C
Insert door (frame)
Insert bracket
below frame
Insert screw & fasten
(First drill 1 /
8
"
pilot holes)
Alternate method
(insert door, drill pilot holes, install screws)