Flowserve HED Worthington User Manual
Page 25
HED/HED-DS USER INSTRUCTIONS ENGLISH 85392695 – 06/14
Page 25 of 64
Figure 5.4
5.1.1.3 KTB Lubrication
The oil circulation is ensured by an high pressure
system according to the description as follow.
Line bearing & thrust bearings side lubrication:
High pressure oil pass through bearing
housing hole to the bearings;
The oil returns into the oil sump once it flows
into the bearings.
Figure 5.5
5.1.2 TRICO oiler setting (standard)
TRICO is used only on ball ball lubrication and sleeve
ball lubrication:
a) Initial fill via top of housing, using overflow plug to
establish correct level.
b) Release thumb screw and remove bottle.
Establish a measurement from the centre line of
the oiler connection in bearing housing to the
upper cross arm of 6 mm (0.24 in.); this can be
obtained by completely screwing down the lower
arm as illustrated on figure 5.6.
c) Fill bottle with recommended oil and install on
holder. Remove and fill bottle as many times as is