Flowserve HED Worthington - Manual (Page 62)

HED/HED-DS USER INSTRUCTIONS ENGLISH 85392695 – 06/14
Page 62 of 64
8.16 General arrangement drawing
The typical general arrangement drawing and any
specific drawings required by the contract will be
sent to the Purchaser separately unless the
contract specifically calls for these to be included
into the User Instructions. If required, copies of
other drawings sent separately to the Purchaser
should be obtained from the Purchaser and
retained with these User Instructions
9 CERTIFICATION
Certificates determined from the Contract
requirements are provided with these instructions
where applicable. Examples are certificates for CE
marking, ATEX marking etc. If required, copies of
other certificates sent separately to the Purchaser
should be obtained from the Purchaser for retention
with these User Instructions.
10 OTHER RELEVANT
DOCUMENTATION AND MANUALS
10.1 Supplementary User Instruction
manuals
Supplementary instruction determined from the
contract requirements for inclusion into User
Instructions such as for a driver, instrumentation,
controller, sub-driver, seals, sealant system,
mounting component etc are included under this
section. If further copies of these are required they
should be obtained from the purchaser for retention
with these User Instructions.
10.2 Change notes
If any changes, agreed with Flowserve, are made
to the product after its supply, a record of the
details should be maintained with these User
Instructions.
10.3 Additional sources of information
Reference 1:
NPSH for Rotordynamic Pumps: a reference guide,
Europump Guide No. 1, Europump & World Pumps,
Elsevier Science, United Kingdom, 1999.
Reference 2:
Pumping Manual, 9
th edition, T.C. Dickenson,
Elsevier Advanced Technology, United Kingdom,
1995.
Reference 3:
Pump Handbook, 2
nd
edition, Igor J. Karassik et al,
McGraw-Hill Inc., New York, 1993.
Reference 4:
ANSI/HI 1.1-1.5
Centrifugal Pumps - Nomenclature, Definitions,
Application and Operation.
Reference 5:
ANSI B 31 3- Process Piping.