Datalogic Scanning QUICKSCAN QD 2300 - Manual (Page 120)

Symbologies
114 QuickScan ® L
Code 32 Prefix
Scan the appropriate bar code below to enable or disable adding the prefix character “A”
to all Code 32 bar codes.
Set Lengths for Code 39
The length of a code refers to the number of characters (i.e., human readable characters),
including check digit(s) the code contains. Set lengths for Code 39 to any length, one or
two discrete lengths, or lengths within a specific range. If Code 39 Full ASCII is enabled,
Length Within a Range or Any Length are the preferred options.
• One Discrete Length - Select this option to decode only Code 39 bar codes containing a
selected length. Select the length using the numeric bar codes in
Appendix E, Keypad .
For example, to decode only Code 39 bar codes with 14 characters, scan Code 39 - One
Discrete Length, then scan 1 followed by 4. To correct an error or change the selection,
scan the CANCEL bar code located in
Appendix E, Keypad .
• Two Discrete Lengths - Select this option to decode only Code 39 bar codes contain-
ing either of two selected lengths. Select lengths using the numeric bar codes in
Appen-
dix E, Keypad . For example, to decode only those Code 39 bar codes containing either 2
or 14 characters, select Code 39 - Two Discrete Lengths, then scan 0, 2, 1, and then
4. To correct an error or change the selection, scan the CANCEL bar code located in
Appendix E, Keypad .
NOTE
Convert Code 39 to Code 32 must be enabled for this parameter to function.
Enable Code 32 Prefix
*
Disable Code 32 Prefix
NOTE
When setting lengths for different bar code types by scanning single digit
numbers, single digit numbers must always be preceded by a leading zero.