Datalogic Scanning QUICKSCAN QD 2300 - Manual (Page 27)

Default Parameters
Product Reference Guide 21
Default Parameters
The scanner can be reset using one of two default settings: factory defaults or custom de-
faults. Scan the appropriate bar code(s) below to reset the scanner to its default settings
and/or set the scanner’s current settings as the custom default.
Set Factory Defaults — Scan the Set Factory Defaults bar code below to eliminate all
custom default values and return the scanner to factory default values. (For factory de-
fault values, see
Appendix B, Standard Defaults .)
Write to Custom Defaults — Custom default parameters can be configured to set
unique default values for all parameters. After changing all parameters to the desired de-
fault values, scan the Write to Custom Defaults bar code below to configure custom de-
faults.
Restore Defaults
Resets all default parameters as follows:
• If custom default values were configured (see Write to Custom Defaults above), the cus-
tom default values are set for all parameters each time the Restore Defaults bar code below
is scanned.
• If no custom default values were configured, the factory default values are set for all
parameters each time the Restore Defaults bar code below is scanned. (For factory default
values, see
Appendix B, Standard Defaults .)
Set Factory Defaults
Write to Custom Defaults
*
Restore Defaults