Datalogic Scanning QUICKSCAN QD 2300 - Manual (Page 157)

Product Reference Guide 151
Appendix B
Standard Defaults
The most common configuration settings are listed in the “Default” column of the table
below. Page references are also provided for feature descriptions and programming bar
codes for each parameter. A column has also been provided for recording of your pre-
ferred default settings for these same configurable features.
Table 30. Standard Defaults
Parameter Default Your Setting Page Number
General Features
Set Default Parameter Restore Defaults 21
Beeper Tone Medium 22
Beeper Volume High 22
Power Mode Continuous On 23
Scan Line Width Full Width 25
Laser On Time 3.0 Sec 25
Beep After Good Read Enable 26
Transmit Label ID None 26
Global Prefix/Suffix Data As Is 28
Prefix Value 7013 <CR><LF> 29
Suffix Value 7013 <CR><LF> 29
FN1 Substitution Values Set 30
Transmit “No Read” Message Disable 30
Keyboard Wedge Host Parameters
Keyboard Wedge Host Type
IBM PC/AT& IBM PC
Compatibles
1
57
Country Types (Country Codes) North American 58
Ignore Unknown Characters Send 59
1
User selection is required to configure this interface and this is the most common selection.