Datalogic Scanning QUICKSCAN QD 2300 - Manual (Page 36)

General Features
30 QuickScan ® L
FN1 Substitution Values
The Wedge and USB HID Keyboard hosts support an FN1 substitution feature. When
enabled, any FN1 character (0x1b) in an EAN128 bar code is substituted with a value.
This value defaults to 7013 (Enter Key).
To select an FN1 substitution value via bar code menus:
1. Scan the bar code below.
2. Look up the keystroke desired for FN1 Substitution in Appendix F, ASCII Character
Sets for the currently installed host interface.
3. Enter the 4-digit substitution value by scanning each digit in Appendix E, Keypad .
To correct an error or change the selection, scan Cancel.
To enable FN1 substitution for keyboard wedge, scan the
Enable FN1 Substitution
on page 63 .
To enable FN1 Substitution for USB HID keyboard, scan the Enable FN1 Substitu-
tion on page 82 .
Transmit “No Read” Message
Scan a bar code below to select whether or not to transmit a No Read message. When
enabled, the characters NR are transmitted when a bar code is not decoded. When dis-
abled, if a bar code does not decode, nothing is sent to the host.
*
Set FN1 Substitution Value
Enable No Read
*
Disable No Read