FSR CB-12 / CB-12P ELECTRICAL HOOKUP INSTRUCTIONS - Manual (Page 3)

Page 3 of 4 43185 LIT1417
5) Install prewired single receptacle in electrical box cover by passing attached wires
through hole in cover and pushing fully into place. Note orientation of attached wires in
figure 4.
Figure 4
6) Push wire the single and duplex receptacles as shown in figure 4 using #14 AWG solid
copper wire, noting applicable strip lengths and polarity.
7) Bring a 14 AWG copper branch circuit feed wire in through desired k/o and attach with
appropriate clamp hardware. Un-sheath a suitable length (about 8-10") of wire.
8) Strip full length of insulation from the end of the branch circuit ground wire if it is
insulated, and pass wire through supplied green ground bond wire nut. Form a loop at
end of bare copper ground wire for attachment to chassis ground bond screw.
9) Strip 1" of insulation from the ground wire of the single receptacle. Join with the ground
wires of the two duplex receptacles while holding the ends even. Push firmly into the
green ground bond wire nut and twist in a normal manner, leaving about 2" from the
looped wire end to the ground bond wire nut as shown in figure 5.
Figure 5