FSR RGB-144 - Manual (Page 5)

LIT1002
TECHNICAL SPECIFICATIONS
400 MHz video bandwidth All metal enclosure
Four bridgeable 1x4 D/A Blocks Blocks Rack mount ears included
All outputs are fully buffered Universal worldwide power supply
Video
Gain: Unity (into 75 ohm load)
Bandwidth: >400MHz (+0.1db/-3db) measured from input connector to output connector
within a block, all outputs connected.
+0.1db/-0.5db 175MHz measured from input connector to output
connector within a block, all outputs connected.
>350MHz (+0.1db /-3db) measured from input to any output connector when
fully bridged , all outputs connected.
+0.1db/-0.5db 150MHz measured from input connector to output
connector when fully bridged, all outputs connected.
Differential Phase Error: 0.04 degrees (NTSC)
Differential Gain Error: 0.04 % (NTSC)
Video Input – Each Block (4 blocks total)
Number/Signal Type: 1 RGBHV, RGBS, RGsB, RsBsGs, component video, composite video, S-video
Connectors: 5 BNC Female
Video Level: ±1.0Vp-p (nominal); 2.0Vp-p (maximum)
Impedance: 75 ohm
Maximum DC offset: ±1.2V (with 0.7Vp-p signal)
Video Output – Each Block (4 blocks total)
Number/Signal Type: 4 Matching input type
Connectors: 5 BNC per output (20 total)
Video Level: ±1.0Vp-p (nominal); 2.0Vp-p (maximum)
Impedance: 75 ohm
Maximum DC offset: ±20MV max
H&V Sync Inputs:
Type: TTL or Analog sync positive or negative polarity (universal sync input)
Level: 0.7 - 5Vp-p; Sync on green 0.3V
Frequency: 50 Hz - 150 KHz on either sync channel
Impedance: 75 ohm
Max Rise/Fall Time: No limit on input rise/fall time due to advanced sync detection circuitry
H&V Sync Outputs:
Level: TTL sync, 2.0Vp-p into 75 ohm load
Rise/Fall Time: 900ps into 75 ohm load
Max propagation delay: 15 ns (each block)
Output Impedance: 75 ohm
GENERAL
Power AC input: 110/220 VAC, 50/60 Hz
Mounting: Table top or rack mount, rack ears included
Enclosure Type/Size: Metal, 3 RU high,19” wide