FSR HD-H70-SP - Manual (Page 7)

7
HD-H70-SP-Tx Rear Panel
ID Name Description
1 Power Connect to a power supply via a power adapter to either
the transmitter or receiver side 18VDC input.
Note: It is only necessary to power one side (Tx or Rx)
2 HDBT
OUT
RJ-45 connection to the receiver via a CAT5e/CAT6
CAT6A / CAT7 cable.
3 IR IN Connect to an IR receiver cable.
4 IR OUT Connect to an IR emitter cable.
5 RS-232 Used to connect to a computer to update firmware or
connect a RS-232 control device.
6 HDMI IN Connect to a source device via an HDMI cable.
7 Switch
Normal:
HD -H70 -SP- Tx
DC 18V HDB T OUT HD MI IN RS -232 IR IN IR OUT
RS-232
MODE
IR IN IR O UT Tx Rx HD MI I N +
-
1 2 3 4 5 6 7