GAI-Tronics 226-700 Hanset VoIP Telephones with Keypad - Manual (Page 14)

P UB . 42004-445H
V O IP I NDUSTRIAL H ANDSET T ELEPHONES P AGE 12 of 24
f:\standard ioms - current release\42004 instr. manuals\42004-445h.doc
02/15
Model 276-700
Figure 10. Model 276-700 Outline Drawing
Stanchion or Flush-Mount Applications
1. Use the supplied back box to mount the Model 276-700 VoIP Telephone in flush-mount applications
or in a GAI-Tronics Model 234 Series Stanchion. Mount the back box to the structure using the
appropriate hardware. Refer to Figure 11 cutout dimensions.
N OTES :
 When installing a Flush-mount VoIP Telephone in a GAI-Tronics 236-00x Series or 238-001
Surface-Mount Enclosure, the front panel assembly mounts directly to the enclosure (back box is
not required.)
 When mounting outdoors, the installation of a (customer-supplied) surge suppressor on the
Ethernet line is recommended, and the power line, if used.
2. Remove a tapered plug from one of the cable entry holes in the back box, and install the cabling and
cable fitting. See the “Field Wire Installation” section on page 14.
3. Use silicone sealant or equivalent around and inside all conduit entries.
4. Connect any desired peripheral devices. Refer to page 16 for connection information.
5. Perform the initial programming of the telephone. Refer to the “Programming” section beginning on
page 19.
6. Verify operation by calling to and from another telephone. Verify operation of peripheral equipment.
7. Attach the telephone’s front panel to the mounting flanges of the back box using the six supplied
#10-32 security screws and washers, 10–12 in-lbs. of torque recommended.