GAI-Tronics 226-700 Hanset VoIP Telephones with Keypad - Manual (Page 20)

P UB . 42004-445H
V O IP I NDUSTRIAL H ANDSET T ELEPHONES P AGE 18 of 24
f:\standard ioms - current release\42004 instr. manuals\42004-445h.doc
02/15
Status Indication
Power
The Power LED located on the VoIP PCBA illuminates when power is applied to the telephone. Refer to
Figure 12 on page 15 for location.
Heartbeat
The Heartbeat LED located on the VoIP PCBA will flash once communication over the LAN is
established. Refer to Figure 12 on page 15 for location.
EACT
The EACT LED located on the VoIP PCBA will turn ON when VoIP PCBA is connected to an Ethernet
device and flash when data is being transmitted. Refer to Figure 12 on page 15 for location.
External Controls
Handset Receiver Volume Control
A push-button switch is provided on the face plate for adjustment of the handset receiver volume. When
pressed, it incrementally increases the volume from 0 dB to 12 dB, to 20 dB, and back to 0 dB of the
original signal. After the end of each call the signal level is automatically set to 0 dB.
Maximum (Handset Receiver) Level Remote Control
The receiver volume level can be controlled remotely by changing the setting in the configuration file.
Refer to the “Handset Volume Setting in the Audio Setting” section in Pub. 42004-396 for programming
instructions.